Talk:Old Laser Cutter: Revision history

20 December 2022

• curprev 14:3514:35, 20 December 2022 AlexN talk contribs m 4,530 bytes 0 AlexN moved page Talk:Laser Cutter to Talk:Old Laser Cutter without leaving a redirect

17 June 2021

• curprev 18:3018:30, 17 June 2021 AlexN talk contribs 4,530 bytes +3 →Resources for working on firmware
• curprev 18:2918:29, 17 June 2021 AlexN talk contribs 4,527 bytes +679 →Resources for working on firmware: new section

4 September 2020

• curprev 11:1511:15, 4 September 2020 AlexN talk contribs 3,848 bytes +3,848 Created page with "Saved these old instructions just in case! --~~~~ ==Making a GCode file - VCarve Pro (old instructions)== On the computer for the laser cutter, there is a version of VCarve P..."