Category:CNC Routers: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
removing details about the Fireball V90 |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
[[File: | [[File:CNC "Room".jpg|400px|thumb|Shapeoko 5 visible up front, with Shapeoko 3 against back wall]] | ||
==About our machines== | ==About our machines== | ||
*This page is for info relating to our various CNC Routers. | *This page is for info relating to our various CNC Routers. | ||
*Models: | *Models: | ||
**[[Shapeoko 3]] (33"x17") | |||
**[[Shapeoko]] | **[[Shapeoko 5]] (48"x48") | ||
**[[Shapeoko 5]] | |||
*Software: | *Software: | ||
**VCarve Pro | **VCarve Pro | ||
| Line 14: | Line 12: | ||
==Guides and Manuals== | ==Guides and Manuals== | ||
Machines: | Machines: | ||
*[http://shapeoko.com/wiki/ Shapeoko CNC Wiki] | *[http://shapeoko.com/wiki/ Shapeoko CNC Wiki] | ||
| Line 42: | Line 39: | ||
*60 Degree V-bit (1/2" shank) | *60 Degree V-bit (1/2" shank) | ||
*90 Degree V-bit (1/2" shank) | *90 Degree V-bit (1/2" shank) | ||
==Other Resources== | ==Other Resources== | ||
Latest revision as of 15:15, 5 July 2025
About our machines
- This page is for info relating to our various CNC Routers.
- Models:
- Shapeoko 3 (33"x17")
- Shapeoko 5 (48"x48")
- Software:
- VCarve Pro
- CamBam
Guides and Manuals
Machines:
Software:
- VCarve Pro
- [Carbide Motion]
Safety
- Never leave a CNC machine running unattended! If it crashes and you're not around to stop it, a lot of damage could be done to the machine and your workpiece.
- Wear safety glasses and hearing protection.
Helpful Videos
Tooling Available
There are a few bits we keep in stock:
- 1/4 Endmill
- 1/8 Endmills
- 60 Degree V-bit (1/2" shank)
- 90 Degree V-bit (1/2" shank)
Other Resources
- Feeds and Speeds
- https://community.carbide3d.com/t/shapeoko-feeds-and-speeds-chart-reformatted/5467
- https://shapeokoenthusiasts.gitbook.io/shapeoko-cnc-a-to-z/feeds-and-speeds-basics
- https://www.cnccookbook.com/feeds-speeds/
- https://makezine.com/article/digital-fabrication/machining/cnc-routing-basics-toolpaths-and-feeds-n-speeds/
- Calibrating Feeds and Speeds
- 50 Digital Wood Joints
- GCode Introduction
- Autotracer - web-based tool to vectorize regular images
- Convert anything to anything
- Calculator for finding width or depth of cut for a V-bit
- Invetables - Materials
Pages in category "CNC Routers"
The following 2 pages are in this category, out of 2 total.